Unable to control XY axis movement

Technician April 5, 2021, 7:27am 1

1.Possible cause analysis of failure:“Jog setting” is set on the operation panel.
2.Solution:Reset to zero.

Topic	Replies	Views
Switch to manual mode, press the Z+, Z- buttons on the operation panel, Z Shaft motor does not move FAQ	262	April 5, 2021
XY axis does not move when reset FAQ	288	April 5, 2021
When the reset is started,the X axis stops after touching the limit switch,while the Y axis is still running very slowly FAQ	291	March 30, 2021
XY axis limit does not work FAQ	313	April 5, 2021
Use a servo drive.The circle cutting is not closed,the line is not straight and the X,Y axis jitter FAQ	265	March 30, 2021