When the reset is started,the X axis stops after touching the limit switch,while the Y axis is still running very slowly

Technician March 30, 2021, 2:42am 1

1.Possible cause analysis of failure:Maybe the Y-axis is the opposite polarity.
2.Solution:Reset the polarity.

Topic	Replies	Views
XY axis limit does not work FAQ	313	April 5, 2021
XY axis does not move when reset FAQ	288	April 5, 2021
When starting the reset,the shaft has been touching the voltage limit switch FAQ	295	March 30, 2021
Switch to manual mode, press the Z+, Z- buttons on the operation panel, Z Shaft motor does not move FAQ	262	April 5, 2021
The panel does not indicate the hard limit protection when the Z axis reaches the hard limit switch FAQ	288	March 23, 2021