Don't know how to set the parameters of camera of the CCD software

1.Possible cause anlysis of failure:Don’t know to operate the software
2.Solution:Click the camera parameters on the software interface and follow the instructions:
(1)After cutting the cross,moving the camera to the position of the crosshair just cut,and make the crosshair on the software coincide with the crosshair cut,and then click “Distance Correction”.Then use a ruler to measure the size seen on the software video interface and fill in “width:X,height:H” parameter.
(2)Dot:The light time is generally set at 0.2s,and then click “Dot” and correct.
(3)Cut the cross again.If it is not straight,align the cross before correcting it.