The way to connect the controller to the network

CO2 Laser Cutting & Engraving FAQ
1

4
1.Set the IP address as 192.168.X.Y in panel and software RDworks.For example,IP is 192.168.8.8.
Panel Gateway is 242.57.0.0.
2.When connecting the main board and PC terminal through network cable,the computer IP should be modified to make the computer IP address and IP address of the main board in the same network segment.The last 8 bit value for IP address should be 1-49.For example,the computer IP address can be set to 192.168.8.28.

5
1.Set the IP address as 192.168.X.Y in panel and software RDworks.For example,IP is 192.168.8.8.
Panel Gateway is 242.57.0.0.
2.When connecting the main board and PC terminal through network cable,the computer IP should be modified to make the computer IP address and IP address of the main board in the same network segment.The last 8 bit value for IP address should be 1-49.For example,the computer IP address can be set to 192.168.8.28.
The DNS on the computer side needs to be set to match the router.