Anchor point is useless

Technician April 5, 2021, 8:46am 1

1.Possible cause analysis of failure:“Multiple Anchor Point Settings” is set on the panel.
2.Solution:Reset to no.

Topic	Replies	Views
The docking position of the laser head is not at the positioning point after the work is completed FAQ	242	April 5, 2021
The starting point of the cutting figure is not at the anchor point FAQ	199	April 5, 2021
Setting the cutting point is invalid FAQ	296	April 5, 2021
When cutting,the graphic word is crooked FAQ	227	March 22, 2021
After correcting the cut cross,the cut cross is not even,or has deviation FAQ	242	March 30, 2021