How to set the cutting starting point and direction

Technician March 30, 2021, 2:11am 1

Check the “Set cut point” box in software editing.Double-click to see the direction.

Topic	Replies	Views
Setting the cutting point is invalid FAQ	336	April 5, 2021
The starting point of the cutting figure is not at the anchor point FAQ	240	April 5, 2021
How to adjust the step length on the software：RDworks CO2 Laser Cutting & Engraving	1142	April 28, 2021
Introduction line of Metalcut software FAQ	257	April 5, 2021
The problem with the parameters setting for V6342 FAQ	268	March 30, 2021