For the RDworks V8 software.After change the idle acceleration in the cutting parameters of the user parameters,writting parameters is invalid

Technician April 1, 2021, 6:31am 1

Solution:The idle acceleration should be greater than or equal to the turn acceleration.

Topic		Replies	Views
Aceleración controlador rdc6432g CO2 Laser Cutting & Engraving	2	367	September 9, 2021
Setting the cutting point is invalid FAQ	0	333	April 5, 2021
The cutting pattern is not closed or the light is uneven FAQ	0	270	April 5, 2021
The panel does not indicate the hard limit protection when the Z axis reaches the hard limit switch FAQ	0	289	March 23, 2021
The cutting figure is not closed FAQ	0	250	March 30, 2021