Cloudray MHX D125 Rotary Attachment

I purchased the above rotary attachment and I am having trouble with smooth performance on my Co2 laser machine.

Between lines the movement seems to be a bit jerky and causes rounded edges of engravings to be jagged. I have a smaller 80mm chuck rotary that does not exhibit this issue. At time of purchase I was told that this would be appropriate for my CO2 laser. Is there any way to smooth out the movement to remove the jaggedness on rounded edges? I have tried multiple micro step settings to no avail.

Hello sir, This is a document about Laser marking machine install drive and can refer to it for debugging.Feel free to contact me if you have any questions.激光打标机安装驱动和回转.pdf (338.4 KB)

Thank you for the information. Do you have a suggestion regarding micro step settings form my rotary. It has a leedshine dm860 controller and a 86CM45 stepper. I have the amps set to 6