Hello, after downloading the latest update for lightburn (1.6.00) my 30w fiber laser has been having some issues. Some examples being: when I run the preview in light burn the actual laser job goes backwards, like it starts the job where it is supposed to end on the preview if that makes sense. And the most obvious issue that made me realize something was wrong is that the cut settings were off. My cut was set to have 2 passes and I watched the job and it only did 1 pass as well as the power was off. Ended up wasting about 5 tumblers before realizing the issue. So frustrating! Anyone else encounter this or something similar and if so how was it resolved? Thank you!