# Standard or recommended machine settings for a 60W Laser Engraver?

**URL:** <https://forum.cloudray.com/t/standard-or-recommended-machine-settings-for-a-60w-laser-engraver/1689>\
**Category:** CO2 Laser Cutting & Engraving\
**Created:** [June 6, 2025, 5:19pm UTC](https://forum.cloudray.com/t/standard-or-recommended-machine-settings-for-a-60w-laser-engraver/1689 "2025-06-06T17:19:01Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Grizz](https://avatars.discourse-cdn.com/v4/letter/g/9e8a1a/32.png) [@Grizz](https://forum.cloudray.com/u/Grizz)\
**Post date:** [June 6, 2025, 5:19pm UTC](https://forum.cloudray.com/t/standard-or-recommended-machine-settings-for-a-60w-laser-engraver/1689/1 "2025-06-06T17:19:01Z")

</div>

HELP! I recently upgraded from a Leethro controller to a Cloudray Ruida Controller RDC6442S-B (EC) so I can use Lightburn and trying to figure out what **machine settings** I should load in Lightburn. I have the following:

Rabbit Laser Machine  
Model HX6090-60E  
60W  
Cloudray Ruida Controller RDC6442S-B (EC)

Do you have a standard or recommended machine settings for a 60W Laser Engraver?

or

Do you have a standard or recommended machine settings Cloudray Ruida Controller (RDC6442S-B (EC)?

I am wondering if there is a document somewhere with a general guide or recommended baseline machine settings for a 60W? Like what are the standard or recommended X / Y acceleration speeds for 60W? Thank you in advance for your time and support!